Selleys Autofix Supa Glue

1. Carefully pierce the tube with the reverse end of the cap. Ensure that the tube is not squeezed while the seal is being pierced. Replace plastic nozzle.
   
2. Surfaces for repair should fit exactly and should be clean, dry and free of dust, dirt and grease.
   
3. Apply a drop of Autofix Supa Glue to only one of the surfaces to be joined. Use sparingly. DO NOT spread.
   
4. Quickly align both surfaces and apply slight pressure to ensure effective spreading and bond.
   
5. Wipe tip of tube and replace cap.

        Limitations:

• Water resistant not water proof, therefore not suitable for surfaces that will be continually wet.
  
• *Not suitable for bonding plastics such as Polypropylene and Polyethylene. Use Selleys All Plastic Fix.
  
• Not suitable for repairing items that are in direct contact with hot liquids eg saucepans.
  
• Will not permanently bond glass or materials containing alkaline elements.
  
• Has no gap filling properties therefore surfaces need to be a close fit.
  
• Not recommended for highly porous surfaces.
  
• Not recommended for glass. Use Selleys Araldite Ultra Clear.

• Supa Glue can create a white residue on the surface of a material if the area is not well ventilated.  Clean the affected area with acetone (most nail polish removers) to remove residue.
  
• Excellent when used with other adhesives, as the temporary tack.
  
• After use, wipe excess product from the nozzle with a tissue dipped in nail polish remover.
  
• In the event that fingers get stuck together, slowly twist fingers in opposite direction in hot soapy water.
  
• Acetone (most nail polish removers) or Olive oil can also be used to remove Quick Fix from skin.
  
• Since Quick Fix cures with moisture set times may be extended on very dry surfaces or under dry conditions.
  
• Supa glues cure more slowly when large amounts are used. For faster cure use sparingly.
  
• To remove excess from materials, it is recommended that the material be soaked in a solution of acetone and water (i.e. 3 parts acetone to 1 part water). Where soaking is not possible, try placing a piece of  absorbant material (eg cotton wool) soaked in acetone on the excess for 5 to 10 minutes, topping up the acetone if it evaporates. Gently rub the surface with the material to remove the residues. TEST THE SURFACE IN AN INCONSPICUOUS SPOT to ensure it is unaffected by acetone before attempting removal using this method.
  
• Do not squeeze tube before removing cap. Handle tube by plastic nozzle neck when opening and closing cap. This prevents pressurising tube which may force material into cap, preventing a tight seal after use. 
  
• May cause some leather to discolour or harden – pre-test on an inconspicuous area.
  

• Uncured product may be removed with acetone.
• Cured product can be sanded and scraped