Selleys Fix&Go Brush On Supa Glue

1. Ensure surfaces to be bonded are clean, dry, free of dust, and close fitting.
   
2. Unscrew cap and apply a small amount of glue to one surface only.
   
3. Bring surfaces together and apply slight pressure. Allow 30 minutes for sufficient bond strength for practical use. Maximum bond strength reached after 24 hours.
   
4. Ensure cap is replaced immediately after applying adhesive, as this prolongs the life of the brush applicator. Store in a cool, dry place out of direct sunlight.

        Limitations:

• *Not suitable for bonding plastics such as Polypropylene and Polyethylene. Use Selleys All Plastic Fix.
  
• Not for glass. Use Selleys Araldite Ultra Clear.
  
• Not suitable for repairing items that are in direct contact with hot liquids.
  
• Will not permanently bond glass or materials containing alkaline elements.
  
• May cause some Leather to harden or discolour. Pre-test on inconspicuous area.
  
• Has no gap filling properties therefore surfaces need to be a close fit.
  
• Not recommended for highly porous surfaces.
  
• Water resistant not waterproof, therefore not suitable for surfaces that will be continually wet.
  

• On very porous materials apply a layer on both surfaces and allow to dry before a second application is used to bond the materials together
  
• Cyanoacrylate adhesives can create a white residue on the surface of a substrate if the area is not well ventilated. Clean the affected area with acetone to remove residue.
  
• Excellent when used with other adhesives, as a temporary tack.
  
• In the event that fingers get stuck together, apply a solvent such as acetone to contact areas then wash off with water. Do not use solvents near eyes or open wounds.
  
• Since Supa Glue cures with moisture, set times may be extended on very dry surfaces or under dry conditions.
  
• Supa glues cure more slowly when large amounts are used.  For faster cure use sparingly.
  
• To remove excess from substrates, it is recommended that the material be soaked in a solution of acetone and water (i.e. 3 parts acetone to 1 part water). Where soaking is not possible, try placing a piece of  absorbant material (eg cotton wool) soaked in acetone on the excess for 5 to 10 minutes, topping up the acetone if it evaporates. Gently rub the surface with the material to remove the residues.  Test the surface in an inconspicuous spot to ensure it is unaffected by acetone before attempting removal using this method.

• Uncured product may be removed with acetone.
• Cured product can be sanded and scraped.